Engineering, 16.07.2021 06:20, tre9990

zener shunt regulator employs a 9.1-V zener diode for which VZ = 9.1 V at IZ = 9 mA, with rz = 40 and IZK= 0.5 mA. The available supply voltage of 15 V can varyas much as ±10%. For this diode, what is the value of VZ0?For a nominal load resistance RL of 1 k and a nominal zenercurrent of 10 mA, what current must flow in the supply resistorR? For the nominal value of supply voltage, select a valuefor resistor R, specified to one significant digit, to provideat least that current. What nominal output voltage results?For a ±10% change in the supply voltage, what variationin output voltage results? If the load current is reduced by50%, what increase in VO results? What is the smallest valueof load resistance that can be tolerated while maintainingregulation when the supply voltage is low? What is the lowestpossible output voltage that results? Calculate values for theline regulation and for the load regulation for this circuit usingthe numerical results obtained in this problem.

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, hadellolo8839

Acompressor receives the shaft work to decrease the pressure of the fluid. a)- true b)- false

Answers: 3

continue

Engineering, 04.07.2019 18:10, abdirahmansoloman

Air is to be cooled in the evaporator section of a refrigerator by passing it over a bank of 0.8-cm-outer-diameter and 0.4-m-long tubes inside which the refrigerant is evaporating at -20°c. air approaches the tube bank in the normal direction at 0°c and 1 atm with a mean velocity of 4 m/s. the tubes are arranged in-line with longitudinal and transverse pitches of sl- st 1.5 cm. there are 30 rows in the flow direction with 15 tubes in each row. determine (a) the refrigeration capacity of this system and (b) pressure drop across the tube bank. evaluate the air properties at an assumed mean temperature of -5°c and 1 atm. is this a good assumption?

Answers: 1

continue

Engineering, 04.07.2019 18:10, DestyHilBan1183

Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.

Answers: 3

continue

Engineering, 04.07.2019 18:20, xcapo1x

Refrigerant-134a enters the compressor of a refrigerator as superheated vapor at 0.14 mpa and -10°c at a rate of 0.05 ka/s and leaves at 0.8 mpa and 50°c. the refrigerant is cooied in the condenser to 0.72 mpa and 26'c. it is then throttled to 0.15 mpa. sketch the t-s diagram for the system and evaluate: 6) the rate of heat removai from the refrigerated space (kw), it) the power input to the compressor (kw), ii) the isentropic efficiency of the compressor (%), and iv) the cop of the refrigerator.

Answers: 2

continue

Do you know the correct answer?

zener shunt regulator employs a 9.1-V zener diode for which VZ = 9.1 V at IZ = 9 mA, with rz = 40 an...