A pipe 200m long slopes down at 1 in 100 and tapers 800mm diameter at the higher end to 400mm diameter at lower end and carries 100 litre/s of oil (s. g 0.85). if the pressure gauge at the higher end reads 50kn/m. determine the velocity at the two end ​

Heat is added to a piston-cylinder device filled with 2 kg of air to raise its temperature 400 c from an initial temperature of t1 27 cand pressure of pi 1 mpa. the process is isobaric process. find a)-the final pressure p2 b)-the heat transfer to the air.

Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.

Draw the engineering stress-strain curve for (a) bcc; (b) fcc metals and mark important points.