Engineering, 13.07.2021 19:10, isabelsmhl

A slab-milling operation is performed on a 0.7 m long, 30 mm-wide cast-iron block with a feed of 0.25 mm/tooth and depth of cut of 3 mm. The cutter has a diameter of 75 mm, has 8 cutting teeth, and rotates at 200 rpm. Calculate the cutting time and material removal rate.

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 12:10, Ryantimes2

On a average work day more than work place firs are reorted

Answers: 1

continue

Engineering, 04.07.2019 18:10, bckyanne3

Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.

Answers: 1

continue

Engineering, 04.07.2019 18:10, winterblanco

The higher the astm grain-size number, the coarser the grain is. a)-true b)-false

Answers: 3

continue

Engineering, 04.07.2019 18:10, genyjoannerubiera

Assuming compressible flow of air and that the measurements are done at flagstaff a pitot static tube that gives the difference of total and static pressure measures 0.35 m of mercury. what is the velocity of air? assume the temperature to be 300k. (submit your excel or matlab calculation sheet)

Answers: 1

continue

Do you know the correct answer?

A slab-milling operation is performed on a 0.7 m long, 30 mm-wide cast-iron block with a feed of 0.2...