Engineering
Engineering, 02.07.2021 15:30, AdoNice

According to the following conditions and requirements, design a reinforced concrete parallel double running stair ( dogleg stair ) of a middle school teaching building. 1. Design conditions
The teaching building of a middle school has three stories, 3.0 m in height, 3.0 m in staircase ( room ) bay ( width ). The minimum depth ( length) is determined by yourself. The entrance and exit are required on the ground floor. The four walls of the staircase ( room ) are ordinary 240mm (wall thickness) bearing brick walls. The height difference between indoor and outdoor is 600mm.

2. Design requirements
1). According to the above conditions, design the width, length, step size and step number of stair flight.
2). Determine the width of intermediate platform and floor platform.
3). Determine the reasonable structural support mode.
4). Determine the form and size of railings.

3、 Drawing requirements
1). Draw three plans of the bottom floor, the second floor and the top floor of the staircase (specify the dimensions of the stair flight, platform, elevation, etc.)
2). Draw the stair’s section, scale 1:50
The reference drawing of stair design is attached at the back

3. (20 points) Draw the roof waterproof methods of accessible roof and non -accessible roof respectively.

answer
Answers: 2

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 18:10, DestyHilBan1183
Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.
Answers: 3
image
Engineering, 04.07.2019 19:20, praveen35301
Amass-spring-viscous damper system of mass 3 kg has a frequency of 100 rad/s and is critically damped. its initial conditions are x(0)-3 mm and (0)-2.3 m/s. does the system overshoot its equilibrium position? prove your answer
Answers: 1
image
Engineering, 05.07.2019 04:30, kookycookiefanx
Technician a says that in a worm gear steering system, most excessive steering free play is usually found in the gearbox. technician b says that in a rack-and-pinion steering system, excessive free play can be found in the bushings. who is correct?
Answers: 2
image
Engineering, 06.07.2019 03:10, serenad2
Different between boring and turning?
Answers: 1
Do you know the correct answer?
According to the following conditions and requirements, design a reinforced concrete parallel double...

Questions in other subjects:

Konu
Mathematics, 22.07.2021 18:00
Konu
Medicine, 22.07.2021 18:00
Konu
Computers and Technology, 22.07.2021 18:00