Engineering, 23.06.2021 23:40, spoo262005

Problem: A bridge can support a maximum of 7 tons, so we need to monitor the weight of vehicles coming in at both ends A and B, where two scales measure the respective weights A and B of the cars. It is assumed that each vehicle weighs fewer than 7 tons.

The operation is then as follows:

If only one vehicle shows up, the barrier (A or B) opens;

If a+b <= 7 tons, barriers A and B open;

If a+b > 7 tons, the barrier corresponding to the lightest vehicle opens,

If a=b, barrier A opens first.

Since A and B are not binary variables, it is necessary to create two binary variables, X and Y, and reformulate the problem statement.

1-Then find the equations of A and B, as a function of x and y,

2-Give the diagram using AND, OR, NOT gates.

Exercise:

Synthesize a synchronous counter modulo 12 with synchronous J-K flip-flops

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, jesuslovesusall3

Courses that are developed by subject matter experts, internal or extemal to the college or university. these programs are marketed by the school (clo2) marks a)-vocational schools b)-vendor training c)-colleges & universities d)-continuing education programs

Answers: 2

continue

Engineering, 04.07.2019 18:10, QueenLife4869

Awall of 0.5m thickness is to be constructed from a material which has average thermal conductivity of 1.4 w/mk. the wall is to be insulated with a material having an average thermal conductivity of 0.35 w/mk so that heat loss per square meter shall not exceed 1450 w. assume inner wall surface temperature of 1200°c and outer surface temperature of the insulation to be 15°c. calculate the thickness of insulation required.

Answers: 3

continue

Engineering, 04.07.2019 19:10, nida7864

An engine, weighing 3000 n, is supported on a pedestal mount. it has been observed that the engine induces vibration into the surrounding area through its pedestal at the maximum operating speed. determine the stiffness of the dynamic vibration absorber spring in (n/m) that will reduce the vibration when mounted on the pedestal. the magnitude of the exciting force is 250 n, and the amplitude of motion of the auxiliary mass is to be limited to 2 mm note: in this question type-in right numbers, no decimals, no fractions, no unit. approximate to right number if needed

Answers: 3

continue

Engineering, 04.07.2019 19:20, mariahmimibrooks

Liquid flows at steady state at a rate of 2 lb/'s through a pump, which operates to raise the elevation of the liquid 100 ft from control volume inlet to exit. the liquid specific enthalpy at the inlet is 40.09 btu/lb and at the exit is 40.94 btub. the pump requires 3 btu/s of power to operate. if kinetic energy effects are negligible and gravitational acceleration is 32.174 tt/s, the heat transfer rate associated with this steady state process is most closely 1)-2,02 btu/s from the liquid to the surroundings 2)-3.98 btu/s from the surroundings to the liquid. 3)-4.96 btu/s from the surroundings to the liquid. 4)-1.04 btu/s from the liquid to the surroundings.

Answers: 2

continue

Do you know the correct answer?

Problem: A bridge can support a maximum of 7 tons, so we need to monitor the weight of vehicles com...