Engineering, 10.06.2021 15:20, tylermdons

Problem 1: We need to build up to 6 power plants (L1 to L6) to serve 7 communities (C1 to C7). The cost to build a power plant is 6.5 million (AED). The maximum capacity of each plant is 11 million watts. The demand of each community is given below: Community 1 2 3 4 5 6 7 Demand in millions watt 3 4 6 4 5 2 4 The benefits (in $/watt but sometimes it is a loss) from serving the community is given below: Location C1 C2 C3 C4 C5 C6 C7 L1 4 4.5 2.5 1.5 3.5 4.2 -0.5 L2 4 4.5 2.5 0.5 1 0.5 -3.5 L3 3.5 5 4 1.5 4.5 3.5 0 L4 1.3 3 5 1.8 5.5 3.3 1.3 L5 0.5 1 1.5 5.5 4 5 3 L6 -1 0 1.5 4.5 4 3.3 2 Find which power plants should be built:

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 19:30, 10040813

When using the ohmmeter function of a digital multimeter, the leads are placed in what position relative to the component being tested? a. parallel b. control c. series d. line

Answers: 3

continue

Engineering, 04.07.2019 18:10, caitlynnpatton1208

Water in a partially filled large tank is to be supplied to the roof top, which is 8 m above the water level in the tank, through a 2.2-cm-internal-diameter pipe by maintaining a constant air pressure of 300 kpa (gage) in the tank. if the head loss in the piping is 2 m of water, determine the discharge rate of the supply of water to the roof top in liters per second.

Answers: 3

continue

Engineering, 04.07.2019 18:10, Strick1530

Which of the following components of a pid controlled accumulates the error over time and responds to system error after the error has been accumulated? a)- proportional b)- derivative c)- integral d)- on/off.

Answers: 2

continue

Engineering, 04.07.2019 18:20, rbgrh9465

An open feedwater heater operates at steady state with liquid entering at inlet 1 with t? = 40°c and pl = 1 .2 mpa. water vapor att2-200°c and p2 = 1.2 mpa enters at inlet 2. saturated liquid water exits with a pressure of pa 1.2 mpa. neglect heat transfer with the surroundings and all kinetic and potential energy effects, determine the mass flow rate of steam at inlet 2 if the mass flow rate of liquid water at inlet 1 is given as 2 kg/s.

Answers: 3

continue

Do you know the correct answer?

Problem 1: We need to build up to 6 power plants (L1 to L6) to serve 7 communities (C1 to C7). The c...