Engineering, 10.06.2021 06:40, Jony4359

A SELF-CHECK 3.2
COMPONENT REPLACEMENT
TVL-11
Directions: Identify the term being described in each item.

1. It is one of the factors to consider in selecting replacement parts
that refers to the capability of local market to have the supply.

2. It is one of the factors to consider in selecting replacement parts
that refers to the conformity of the available parts as per
acceptable specification.

3. It is one of the factors to consider in selecting replacement parts
that refers to the ability to provide exact value/ specification.

4. It is one of the factors to consider in selecting replacement parts
that refers to the affordability of the replacement parts.

5. It contains the necessary data of a particular domestic appliance
including the schematic diagram.

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, niyawilliams23

Asingle-geared blanking press has a stroke of 200 mm and a rated capacity of 320 kn. a cam driven ram is assumed to be capable of delivering the full press load at constant force during the last 15 percent of a constant-velocity stroke. the camshaft has an average speed of 90 rev/min and is geared to the flywheel shaft at a 6: 1 ratio. the total work done is to include an allowance of 16 percent for friction a) estimate the maximum energy fluctuation b) find the rim weight for an effective diameter of 1.2 m and a coefficient of speed fluctuation of 0.10

Answers: 1

continue

Engineering, 04.07.2019 18:10, xboxdude06

Slip occurs via two partial dislocations because of (a) the shorter path of the partial dislocation lines; (b) the lower energy state through partial dislocations; (c) the charge balance.

Answers: 1

continue

Engineering, 04.07.2019 19:20, nikkiebartels

Afan that can provide air speeds up to 60 m/s is to be used in a low-speed wind tunnel with atmospheric air at 35 c. if one wishes to use the wind tunnel to study flat-plate boundary layer behavior up to reynolds numbes of re 10, what is the minimum plate length that should be used? at what distance from the leading edge would transition occur if the critical reynolds nurnber were rer, e = 5 × 105?

Answers: 2

continue

Engineering, 06.07.2019 02:30, piperk19

Define thermoplastic polymers and thermosetting polymers in terms of their structures, and (ii) describe briefly a process suitable for the production of products from each type of polymer.

Answers: 3

continue

Do you know the correct answer?

A SELF-CHECK 3.2
COMPONENT REPLACEMENT
TVL-11
Directions: Identify the term being de...