Engineering, 08.06.2021 22:00, insulation62

Which option identifies the next step Kristin should take to test the design in the following scenario? During the design process, Kristin determined that her new automatic-loading pencil sharpener is ready to be tested. She is still concerned that there may need to be some changes before the prototype is created.

She should create a prototype that is flexible enough to make changes to if needed.

She should create a two-dimensional sketch to ensure she has not missed any information.

She should make any changes she feels are necessary before designing a model.

She should create a model using cutting-edge technology programs.

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 14:10, bryneosburn

Line joining liquid phase with liquid and solid phase mixture is known as: a) liquidus b) solidus c) tie line d) none of the mentioned

Answers: 2

continue

Engineering, 04.07.2019 18:10, juansoto227711

Journeyman training is usually related (clo2) a)-to specific tasks b)-to cost analysis of maintenance task c)-to control process to ensure quality d)-to installation of machinery

Answers: 2

continue

Engineering, 06.07.2019 03:20, shelbellingswo

Aload of 10kn is to be suddenly applied to the free end of a vertical rod of length 500 mm, the upper end being rigidly fixed. 190 mechanical science what should the diameter of the rod be if the maximum stress in the rod is not to exceed 100 mpa? the tensile modulus of the rod is 205 gpa.

Answers: 2

continue

Engineering, 06.07.2019 04:20, Jana1517

Consider a beam traveling through diamond and impinging upon the diamond-air interface. the critical angle of incidence for total internal reflection to occur is closest to the following value: select one: a)-22.50° b)-23.85 c)-24.30 d)-23.40° e)-none of the above

Answers: 3

continue

Do you know the correct answer?

Which option identifies the next step Kristin should take to test the design in the following scenar...