Engineering, 05.06.2021 06:40, elijahjacksonrp6z2o7

At an underground coal mine a development heading for a longwall panel has intercepted a fault. The last surveyed station in the roof of the seam was found to
have co-ordinates of E 2788.86, N 5222.92 and RL 2674.00. The seam is very
regular to the west of the surveyed station with a rate of true dip of 4°20'
descending in the direction of 125°20'35". A vertical borehole was drilled at E
3402.76, N 5292.97 and the top of the seam was found to be RL 2658.31.
Calculate the displacement caused by the fault.

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 14:10, makaylashrout77

Amass of 1.5 kg of air at 120 kpa and 24°c is contained in a gas-tight, frictionless piston-cylinder device. the air is now compressed to a final pressure of 720 kpa. during the process, heat is transferred from the air such that the temperature inside the cylinder remains constant. calculate the boundary work input during this process.

Answers: 2

continue

Engineering, 03.07.2019 15:10, breannaasmith1122

Two flowing streams of argon gas are adiabatically mixed to form a single flow/stream. one stream is 1.5 kg/s at 400 kpa and 200 c while the second stream is 2kg/s at 500 kpa and 100 ? . it is stated that the exit state of the mixed single flow of argon gas is 150 c and 300 kpa. assuming there is no work output or input during the mixing process, does this process violate either the first or the second law or both? explain and state all your assumptions.

Answers: 1

continue

Engineering, 04.07.2019 03:10, lauriepdx17

What precautions should you take to prevent injuries when dealing with heavy loads?

Answers: 1

continue

Engineering, 04.07.2019 18:10, koolgurl2003

Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.

Answers: 1

continue

Do you know the correct answer?

At an underground coal mine a development heading for a longwall panel has intercepted a fault. The...