Engineering, 04.06.2021 14:00, lalaween098

As a team lead, you are also responsible for the quality and usability of the softwares developed by your team. After repeated failures of software and negative user feedback, you emphasize to the higher management to hire more HCI oriented software developers. How would you convince the higher management that the proposed hiring can not only lessen cost but also increase revenue, as well? Provide three (3) scenarios/ reasoning in favor of your arguments.

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, lillygrl100

For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater

Answers: 3

continue

Engineering, 04.07.2019 18:10, xboxdude06

Slip occurs via two partial dislocations because of (a) the shorter path of the partial dislocation lines; (b) the lower energy state through partial dislocations; (c) the charge balance.

Answers: 1

continue

Engineering, 04.07.2019 18:10, 0436500

Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.

Answers: 1

continue

Engineering, 04.07.2019 18:20, aly95

An engine runs on the ideal diesel cycle. the cycle has a compression ratio of 20 and a cutoff ratio of 2. the highest temperature in the cycle is 1200 k. if the heat into the system is 300 kj/kg of working fluid and using variable specific heats determine the work produced per mass of working fluid

Answers: 3

continue

Do you know the correct answer?

As a team lead, you are also responsible for the quality and usability of the softwares developed by...