Engineering
Engineering, 02.06.2021 15:40, vickye146

(8 pts.) Air in an Otto cycle engine is compressed to a temperature and pressure of 450 °C and 2.5 MPa. After the power stroke, the conditions are 600 °C and 0.45 MPa. Find the peak cycle temperature (°C), heat addition (kJ/kg), and efficiency

answer
Answers: 1

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 18:10, caitlynnpatton1208
Water in a partially filled large tank is to be supplied to the roof top, which is 8 m above the water level in the tank, through a 2.2-cm-internal-diameter pipe by maintaining a constant air pressure of 300 kpa (gage) in the tank. if the head loss in the piping is 2 m of water, determine the discharge rate of the supply of water to the roof top in liters per second.
Answers: 3
image
Engineering, 04.07.2019 19:20, amandaaarmentaa
Acircular pipe of 30mm outside diameter is placed in an airstream at 30 c and latm pressure. the air moves in cross flow over the pipe at 20 m/s, while the outer surface of the pipe is maintained at 110 c. what is the drag force exerted on the pipe per unit length? what is the rate of heat transfer from the pipe per unit length?
Answers: 1
image
Engineering, 06.07.2019 05:10, bale4
Air flows over a flat plate at a velocity of 3 m/sec and ambient conditions are, the pressure is 761 mm of hg and tempera- ture is 15°c. the plate is maintained at 85°c. if the length of the plate is 100 cm along the flow of the air, find out the heat lost by 50 cm of the plate which is measured from the trailing edge. plate width is 50 cm.
Answers: 1
image
Engineering, 06.07.2019 05:30, yami4458
Aspring-mass system consists of a mass weighing 20 kg and a spring with stiffness of 1000 n/m. the mass is subjected to resonance by a harmonic force f(t) 20 cos wt n. the initial condition is given as the initial position 0 and the initial velocity 0. find the amplitude of the forced motion at the end of (a) 1.5 cycle and (b) 2.25 cycles
Answers: 2
Do you know the correct answer?
(8 pts.) Air in an Otto cycle engine is compressed to a temperature and pressure of 450 °C and 2.5 M...

Questions in other subjects:

Konu
History, 07.12.2021 01:00
Konu
English, 07.12.2021 01:00
Konu
Mathematics, 07.12.2021 01:00