Engineering, 28.05.2021 19:10, elijiahman99

A cold-rolled sheet metal that is 40 mm wide and has a thickness of 5.00 mm is going to be bent into a V shape with a 60° angle. The die opening dimension is 50 mm. Each of the two straight sides of the bent part will be 50 mm long. The bend has a radius of 10 mm. The steel tensile strength is assumed as 400 MPa. Determine:
a. The required blank size to provide the final workpiece dimensions
b. The force required to bend the part

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 14:10, aliceohern

The y form of iron is known as: a) ferrite b) cementite c) perlite d) austenite

Answers: 3

continue

Engineering, 04.07.2019 19:10, jimena15

10 kg of co2 is initially contained at 400 kpa and 300 k. the gas constant for carbon dioxide is 189 j/lkg k) and has a specific heat ratio, k, of 1.289. isentropic expansion then occurs until the pressure is 200 kpa. a) determine the initial volume of co2 in m. b) determine the final temperature in k. c) determine the work done by the system during the expansion kl.

Answers: 2

continue

Engineering, 04.07.2019 19:20, molly7654

Brief discuss how the presence of dislocations in crystal structures can be an advantage and a disadvantage to engineer and designers.

Answers: 3

continue

Engineering, 06.07.2019 03:20, mardell2587

Acountershaft is supported by two tapered roller bearings using indirect mounting. the radial bearing loads are 1120 lb for the left-hand bearing and 2190 lb for the right-hand bearing. the shaft rotates at 400 rpm and is to have an l10 life of 40,000 hours and an application factor of 1.4. assume ka2k 15, and find the required radial rating of each bearing

Answers: 3

continue

Do you know the correct answer?

A cold-rolled sheet metal that is 40 mm wide and has a thickness of 5.00 mm is going to be bent into...