Engineering
Engineering, 26.05.2021 01:40, danacoots

ā€/ determine the discharge in the compound open channel shown in figure assume a bed slope ( 0.001 ) and the Manning coefficient is 0.03 . *pleas i need it fast ā€‹


ā€/ determine the discharge in the compound open channel shown in figure assume a bed slope ( 0.001

answer
Answers: 2

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 18:10, tjeffers90028
Refrigerant 134a enters an insulated compressor operating at steady state as saturated vapor at -26Ā°c with a volumetric flow rate of 0.18 m3/s. refrigerant exits at 9 bar, 70Ā°c. changes in kinetic and potential energy from inlet to exit can be ignored. determine the volumetric flow rate at the exit, in m3/s, and the compressor power, in kw.
Answers: 1
image
Engineering, 04.07.2019 18:10, abdirahmansoloman
Air is to be cooled in the evaporator section of a refrigerator by passing it over a bank of 0.8-cm-outer-diameter and 0.4-m-long tubes inside which the refrigerant is evaporating at -20Ā°c. air approaches the tube bank in the normal direction at 0Ā°c and 1 atm with a mean velocity of 4 m/s. the tubes are arranged in-line with longitudinal and transverse pitches of sl- st 1.5 cm. there are 30 rows in the flow direction with 15 tubes in each row. determine (a) the refrigeration capacity of this system and (b) pressure drop across the tube bank. evaluate the air properties at an assumed mean temperature of -5Ā°c and 1 atm. is this a good assumption?
Answers: 1
image
Engineering, 04.07.2019 18:10, chadatkin
Which of the following ziegler nichols tuning methods the response of the controller to a step input should exhibit an s-shaped curve? a)-open loop mode b)-closed loop mode c)-both modes (open & closed) d)-none of the modes (open & closed)
Answers: 3
image
Engineering, 04.07.2019 19:10, alex6toes
What are the major differences between injection molding and extrusion?
Answers: 2
Do you know the correct answer?
ā€/ determine the discharge in the compound open channel shown in figure assume a bed slope ( 0.001 )...

Questions in other subjects:

Konu
Mathematics, 27.07.2020 18:01
Konu
Mathematics, 27.07.2020 18:01