Determine the hoop stresses at the inside and outside surfaces of a long thick cylinder which is rotated at 4000 rev/min. The cylinder has an internal radius of 80 mm and an
external radius of 250 mm and is constructed from steel, the relevant properties of which
are given above. How would these values be modified if under service conditions the
temperatures of the inside and outside surfaces reached maximum levels of 40°C and 90°C
respectively? A linear thermal gradient may be assumed. For steel a = 11 x 10-6 per c.​

Calculate the bore of a cylinder that has a stroke of 18 inches and an extension time of 6 seconds at a flow rate of 4 gal/min.

Write a technical essay (maximum two pages) about stress concentration. and paste from the textbook. instead, read updated material about this phenomenon and provide a technical evaluation of the different techniques to avoid/reduce such phenomenon. consider in your analysis cutting-edge computational techniques such as fea to study and analyze stress concentrations.

Aheat pump with refrigerant-134a as the working fluid is used to keep a space at 25°c by absorbing heat from geothermal water that enters the evaporator at 500c at a rate of 0.065 kg/s and leaves at 40°c. the refrigerant enters the evaporator at 20°c with a quality of 23 percent and leaves at the inlet pressure as saturated vapor. the refrigerant loses 300 w of heat to the surroundings as it flows through the compressor and the refrigerant leaves the compressor at 1.4 mpa at the same entropy as the inlet. determine: (a) the degrees of subcooling of the refrigerant in the condenser, b)-the mass flow rate of the refrigerant . (c) the heating load and the cop of the pump, and d)-the theoretical minimum power input to the compressor for the same heating load.