Engineering, 21.05.2021 17:00, sonynwz8570
Coal containing 21% ash is completely combusted, and the ash is 100% removed in a water contact scrubber. If 10,000 kg of coal is burned per hour with a scrubber flow rate of 1.0 m3/min, the weight percentage of the ash in the water/ash stream leaving the scrubber is most nearly:.
a. 3.4
b. 14.3
c. 25.9
d. 67.7
Answers: 2
Engineering, 04.07.2019 18:20, hayleymckee
Steam enters a converging nozzle at 3.0 mpa and 500°c with a at 1.8 mpa. for a nozzle exit area of 32 cm2, determine the exit velocity, mass flow rate, and exit mach number if the nozzle: negligible velocity, and it exits (a) is isentropic (b) has an efficiency of 94 percent
Answers: 2
Engineering, 04.07.2019 18:20, RiverH246
Air flows over a heated plate àt a velocity of 50m/s. the local skin factor coefficient at a point on a plate is 0.004. estimate the local heat transfer coefficient at this point. the following property data for air are given: density = 0.88kg/m3 , viscosity 2.286 x 10 ^-5 kgm/s , k = 0.035w/mk ,cp = 1.001kj/kgk. use colburn reynolds analogy.
Answers: 1
Engineering, 04.07.2019 19:10, nbunny7208
What is the chief metrological difference between measuring with a microscope and with an electronic comparator? a. the microscope is limited to small workpieces. a. the microscope is limited to small workpieces. c. the comparator can only examine one point on the workpiece. d. the microscope carries its own standard.
Answers: 1
Engineering, 06.07.2019 02:30, cofran
A75mm diameter shaft is supported in a journal bearing 75mm long with a diametral clearance of 0. 1mm. it supports a radial load of 1000 n and is lubricated with sae 50 oil at 70°c. find the friction torque and the power loss when the crankshaft rotates at 2900 rev/min.
Answers: 1
Coal containing 21% ash is completely combusted, and the ash is 100% removed in a water contact scru...
Mathematics, 24.12.2020 21:40
Mathematics, 24.12.2020 21:40
Mathematics, 24.12.2020 21:40
Mathematics, 24.12.2020 21:40
Mathematics, 24.12.2020 21:40