Engineering, 19.05.2021 18:50, Ksouth13
A series of end-milling cuts is currently used to produce an aluminum part that is an aircraft component. The purpose of the machining operation is to remove 95% of the part weight to create a structural frame. A total of 4.0 min is lost during the milling cycle due to tool repositioning. The part has a length = 1.6 m, width=0 m, and mm. The operation uses a four-tooth indexable-insert end mill with mm at a cutting speed 600 m/min, chip load 0.15 mm/tooth, and average cross-sectional area of cut-240 mm. High-speed machining has to replace the conventional milling process. The same chip load and average area of cut will be used, but the cutting speed will be increased to 3600 m/min , and the time lost for tool repositioning will be reduced to 2.0 min.
Determine :
(a) The cycle time of the current milling operation and
(b) The cycle time of the proposed HSM operation.
(c) Is this part a good candidate for high-speed machining?
Answers: 1
Engineering, 04.07.2019 18:10, danksans7011
The mass flow rate of the fluid remains constant in all steady flow process. a)- true b)- false
Answers: 1
Engineering, 04.07.2019 19:10, pjgolden04
How to increase the thermal officiency of an ideal simple rankino cycle? among these methods, which one is the best and why?
Answers: 2
A series of end-milling cuts is currently used to produce an aluminum part that is an aircraft compo...
Computers and Technology, 12.07.2019 05:30
Computers and Technology, 12.07.2019 05:30
Computers and Technology, 12.07.2019 05:30
Computers and Technology, 12.07.2019 05:30