An annealed copper bar of 1.6inches length and 1 inch diameter was subjected to a tensile test. The following data points were obtained for this materialthrough careful observation and experimental stress determination methods. The engineeringstress at the onset of plastic deformation was 80,000 psi. The modulus of elasticity was 720,000 psi. The strain-hardening index was 0.5. What is the strength coefficient of the material, true yield stress, and the true ultimate stress

During a steady flow process, the change of energy with respect to time is zero. a)- true b)- false

Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.

Ajournal bearing has a journal diameter of 3.250 in with a unilateral tolerance of 20.003 in. the bushing bore has a diameter of 3.256 in and a unilateral tolerance of 0.004 in. the bushing is 2.8 in long and supports a 700-lbf load. the journal speed is 900 rev/min. find the minimum oil film thickness and the maximum film pressure for both sae 20 and sae 20w-30 lubricants, for the tightest assembly if the operating film temperature is 160°f. a computer code is appropriate for solving this problem.