Engineering, 11.05.2021 22:20, starburst2005

A single-cylinder engine head sees forces that range from 0 to 4000 lbs each cycle. The piston is 3 in dia and the cylinder is 5.5 in outside dia. The engine head is permanently fastened with 8 steel bolts of 5/16-18 UNC, Grade 5 that are located around a circle of diameter 4.25 inches. You assistant calculated the bolt and member stiffness values to be 457.3 and 2345 kip/in respectively.(a) Calculate the bolt tightening torque if they are lubricated.(b) Calculate the alternating and mean stresses per bolt.(c) Calculate the Goodman fatigue safety factor if corrected fatigue strength for the bolt material Se

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 08:10, doggo242

Which of the following is an easy way to remember the modified “x” tire rotation? a. nondrive wheels straight, cross the drive wheels b. drive wheels straight, cross the nondrive wheels c. drive wheels crossed, nondrive wheels straight d. drive wheels crossed, nondrive wheels crossed

Answers: 1

continue

Engineering, 04.07.2019 18:10, koolgurl2003

Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.

Answers: 1

continue

Engineering, 04.07.2019 18:10, 0436500

Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.

Answers: 1

continue

Engineering, 04.07.2019 18:20, cristykianpour

Describe one experiment in which the glass transition temperature and melting temperature of a totally amorphous thermoplastic material can be determined. show the relevant experimental results in a diagram which should be properly annotated with the two temperatures clearly marked. what is likely to happen to the curve in the diagram if the amorphous polymer is replaced by a thermosetting type?

Answers: 2

continue

Do you know the correct answer?

A single-cylinder engine head sees forces that range from 0 to 4000 lbs each cycle. The piston is 3...