Engineering, 11.05.2021 20:30, allieballey0727

You are responsible for design and construction of a new freeway. Estimated flow rate for the freeway is each direction in design hour is 7500 vph. The deigned freeway should meet the following conditions: a) It should operate at level of service of B or higher during the design hour and A for the rest of the times. b) The base free flow speed for the freeway is 75 mph and free flow speed should not fall below 70 mph. c) Due to topography constraints, the widths of the cross section cannot exceed 200 ft. d) On average, number of access points to the freeway 2 per mile. What is your recommended design for this section of the freeway

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, alyssabailey7545

Give heat transfer applications for the following, (i) gas turbines (propulsion) ) gas turbines (power generation). (iii) steam turbines. (iv) combined heat and power (chp). (v) automotive engines

Answers: 1

continue

Engineering, 04.07.2019 18:10, qwertylol12345

Different types of steels contain different elements that alter the characteristics of the steel. for each of the following elements, explain what the element does when alloyed with steel.

Answers: 2

continue

Engineering, 04.07.2019 18:10, chadatkin

Which of the following ziegler nichols tuning methods the response of the controller to a step input should exhibit an s-shaped curve? a)-open loop mode b)-closed loop mode c)-both modes (open & closed) d)-none of the modes (open & closed)

Answers: 3

continue

Engineering, 04.07.2019 18:10, katelynn73

Atmospheric air has a temperature (dry bulb) of 80° f and a wet bulb temperature of 60° f when the barometric pressure is 14.696 psia. determine the specific humidity, grains/lb dry air. a. 11.4 c. 55.8 d. 22.5 b. 44.1

Answers: 1

continue

Do you know the correct answer?

You are responsible for design and construction of a new freeway. Estimated flow rate for the freewa...