Engineering, 11.05.2021 20:20, rex12388

Consider circuit below utilizing MOSFETs with VT = 2 V, (W/L)*kn’ = 1 mA/V2 , λ = 0.01 V-1 , CGS = 1 pF and CGD = 0.2 pF. VDD = VSS = 5 V, I0 = 0.5 mA, RS = RD = RL = 10 kΩ, CS = 1 µF, C2 is infinite, i. e. can be replaced with short circuit for all frequencies of interest. 1. Find the mid-band voltage gain; 2. Estimate the low and high 3dB cutoff frequencies fL and fH; 3. Sketch the magnitude frequency response Bode plot and mark it with the values found. 4. Replace RL with CL = 1 nF and repeat 1, 2 and 3.

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 14:10, volleyballfun24

If the thermal strain developed in polyimide film during deposition is given as 0.0044. assume room temperature is kept at 17.3 c, and thermal coefficient of expansion for the film and the substrate are 54 x 10^-6c^-1 and 3.3 x 10^-6c^-1respectively. calculate the deposition temperature.

Answers: 3

continue

Engineering, 04.07.2019 18:10, anna22684

Water at 70°f and streams enter the mixing chamber at the same mass flow rate, determine the temperature and the quality of the exiting stream. 0 psia is heated in a chamber by mixing it with saturated water vapor at 20 psia. if both streams enters the mixing chamber at the same mass flow rate, determine the temperature and the quality of the existing system.

Answers: 2

continue

Engineering, 04.07.2019 18:10, meganwintergirl

Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise

Answers: 3

continue

Engineering, 04.07.2019 18:10, DestyHilBan1183

Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.

Answers: 3

continue

Do you know the correct answer?

Consider circuit below utilizing MOSFETs with VT = 2 V, (W/L)*kn’ = 1 mA/V2 , λ = 0.01 V-1 , CGS = 1...