Engineering
Engineering, 11.05.2021 14:00, TashaKessler3355

Assignment 2 his assignment covers the work done in Topic 3. The marks allocated are shown in bra
end of each question.
Question 1
Write the missing word(s) to complete the following statements:
1.1 To obtain more current capacity, cells are connected in
1.2 A chemical cell is one which converts
energy into
energy
1.3 Transformers have no parts.
1.4 When two resistors are connected in parallel, the voltage across each resistor is the
1.5 In a parallel circuit, an open circuit in one branch results in current throught
but the other branches will still draw their current.
1.6 If each of two bulbs connected in parallel dissipates 100 W, then the total power sur
voltage source is equal to
1.7 One of the advantages of load balancing is that each phase conductor carries the
value.
1.8 In a series circuit the total resistance is than any of the resistors.
[10 x
Question 2
2.1 Two resistors with values of 21 and 6 1 are connected in parallel. This combination
connected in series with a 3 1 resistor. The supply voltage of the whole circuit is 12
2.1.1 Draw a neat, labelled diagram of the circuit.
2.1.2 Calculate the following:
a) the resistance of the parallel pair of resistors
b) the total resistance of the circuit
c) the total current flow of the circuit
d) the voltage drop across each resistor
e) the current flowing through the 2 resistor
f) the current flowing through the 61 resistor.
Direct current (DC) and alternating current (AC) circuits​

answer
Answers: 3

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 18:10, bckyanne3
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
image
Engineering, 04.07.2019 18:10, lowkeyqueenk
Apipe with an outside diameter of 15 cm is exposed to an ambient air and surrounding temperature of -20°c. the pipe has an outer surface temperature of 65°c and an emissivity of 0.85. if the rate of heat loss from the pipe surface is 0.95 kw per meter of length, the external convective heat transfer coefficient (h) is: (a) 12.5 w/m"k (b) 18.6 w/mk (c) 23.7 w/mk (d) 27.9 w/mk (e) 33.5 w/mk
Answers: 1
image
Engineering, 04.07.2019 18:10, tobyhollingsworth178
Which from the following instrument is commonly used to detect the high pitch butzing sound in bearings? [clo4] a)-digital ultrasonic meter b)-infrared camera c)-spectroscopic d)-vibrometer
Answers: 2
image
Engineering, 04.07.2019 18:20, mjcbs21
What is the heat treatment of metals? what is the benefit of it? why and how it's useful? answer in details, do not write by hand.
Answers: 3
Do you know the correct answer?
Assignment 2 his assignment covers the work done in Topic 3. The marks allocated are shown in bra

Questions in other subjects:

Konu
Arts, 10.11.2020 01:00
Konu
Mathematics, 10.11.2020 01:00