Engineering, 08.05.2021 15:20, NickWinston8712

Zone, N = (sum of digits of your student id)% 8 For example, if your student id is 17301283, zone = (1+7+3+0+1+2+8+3) % 8 = 25 % 8 = 1 Derive midpoint line drawing algorithm for a line in zone N. If you find zone 0, i. E., then drop the last digit from sum and take % 8 again. If your student id is 16240524, zone = (1+6+2+4+0+5+2+4)%8 = 24%8 = 0 Updated zone by removing last digit 4 = (1+6+2+4+0+5+2)%8 =20%8 = 4 Derive midpoint circle drawing algorithm for the arc of the circle in zone N. If you find zone 1, i. E., then drop the last digit from sum and take % 8 again. If your student id is 17301283, zone = (1+7+3+0+1+2+8+3)%8 = 25%8= 1 Updated zone by removing last digit 3 = (1+7+3+0+1+2+8)%8 = 22%8= 6

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, wirchakethan23

Hydraulic fluid with a sg. of 0.78 is flowing through a 1.5 in. i. d. pipe at 58 gal/min. the fluid has an absolute viscosity of 11.8 x 105 lbf-sec/ft2. is the flow laminar, turbulent or within the critical range? give both a numerical reynolds number and a term answer.

Answers: 3

continue

Engineering, 04.07.2019 18:10, krystabrewer3

What are the two (02) benefits, which may result from a successful implementation of preventive maintenance (pm) program in an organization? (clo3)a)- lean manufacturing b)-overlapping responsibilities c)-the planner is not qualified d)-accurate contractor information e)-reduction in equipment redundancies f)-accurate stores information

Answers: 3

continue

Engineering, 04.07.2019 18:10, 0436500

Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.

Answers: 1

continue

Engineering, 04.07.2019 18:20, xcapo1x

Refrigerant-134a enters the compressor of a refrigerator as superheated vapor at 0.14 mpa and -10°c at a rate of 0.05 ka/s and leaves at 0.8 mpa and 50°c. the refrigerant is cooied in the condenser to 0.72 mpa and 26'c. it is then throttled to 0.15 mpa. sketch the t-s diagram for the system and evaluate: 6) the rate of heat removai from the refrigerated space (kw), it) the power input to the compressor (kw), ii) the isentropic efficiency of the compressor (%), and iv) the cop of the refrigerator.

Answers: 2

continue

Do you know the correct answer?

Zone, N = (sum of digits of your student id)% 8 For example, if your student id is 17301283, zone =...