Engineering, 08.05.2021 03:30, sabrinarasull1pe6s61

Compute the atomic density (the number of atoms per cm3 rather than mass density g/cm3) for a perfect crystal of silicon at room temperature, given that the room temperature density and atomic weight of silicon are 2.33 g/cm3 and 28.09 g/mol, respectively. Hint: you do NOT need any information about the crystal structure of silicon to solve for this quantity, based on the information provided in this particular problem.
Be sure to use values exactly as given and do not round until the final answer.
Use 6.022x1023 , exactly, for Avogadro's Number.
Answer Format: XEX where EX stands for *10x
Units: atoms/cm3
Example: So for an answer of 158123.126 you would type: 2E5 since only a whole number is prescribed for the prefix.

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:20, Doogsterr

For each of the following process: a) sketch the p-v diagram, b)sketch t-s diagram, c) sketch t-v diagram, d) sketch the boundary work on one of the diagrams (a, b or c) and e) sketch the reversible heat transfer on one of the diagrams (a, b or c): 1- isobaric process from compressed liquid to superheated vapor 2- isothermal process from compressed liquid to superheated vapor 3- isentropic process from compressed liquid to superheated vapor

Answers: 3

continue

Engineering, 04.07.2019 19:10, jennymares

Abarometer contains mercury with a density of 13600 kg/m3. atmospheric conditions are 95.8 kpa and 20 °c at 20 °c, the vapor pressure of the mercury is 0.000173 kpa. the column of mercury will rise to a height of most nearly. select one: a)- 0.38 m b)- 0.82 m c)- 0.48 m d)- 0.72 m

Answers: 1

continue

Engineering, 04.07.2019 19:10, batmanmarie2004

Afoot bridge is made as a simple deck, 4 m long, with a cross section 2 m (wide) and 20 cm thick, and made of wood. the deck is supported at the two ends. the maximum load allowable on the bridge is 10 tons, provided it is uniformly distributed on the deck. to sense this load, a strain gauge is placed at the center of the bridge and its resistance is monitored. if the sensor has a nominal resistance of 350 s2 and a gauge factor of 3.6, what is the reading of the strain gauge at maximum load? the modulus of elasticity for the wood used in the construction is 10 gpa.

Answers: 2

continue

Engineering, 04.07.2019 19:20, mads000

Determine (a) the maximum thermal efficiency of reversible power cycles operating between a hot reservoir at 1000°c and a cold reservoir at 200°c and (b) the maximum cops for reversible refrigeration and heat pump cycies, respectively, between 28°c and 14°c.

Answers: 1

continue

Do you know the correct answer?

Compute the atomic density (the number of atoms per cm3 rather than mass density g/cm3) for a perfec...