Engineering, 08.05.2021 03:00, mya1318

It is desired to develop a strong Aluminum-based alloy with a shear strength on the order of G/100 by precipitation hardening, where G is the shear modulus. Calculate the necessary precipitate spacing, and estimate the required percentage of the precipitate phase. Assume that the precipitate phase consists of spherical particles of radius of R=40 nm with centers uniformly distributed in simple cubic lattice. Does it matter whether the precipitates strain the matrix locally around the interface or not?

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, skpdancer1605

Ariver flows from north to south at 8 km/h. a boat is to cross this river from west to east at a speed of 20 km/h (speed of the boat with respect to the earth/ground). at what angle (in degrees) must the boat be pointed upstream such that it will proceed directly across the river (hint: find the speed of the boat with respect to water/river)? a 288 b. 21.8 c. 326 d. 30.2

Answers: 3

continue

Engineering, 04.07.2019 18:10, aliopqwas

Condition monitoring is a major component of. (clo4) a)- predictive maintenance. b)-preventive maintenance c)-proactive maintenance d)-reactive maintenance.

Answers: 1

continue

Engineering, 04.07.2019 18:10, demarcuswiseman

Calculate the bore of a cylinder that has a stroke of 18 inches and an extension time of 6 seconds at a flow rate of 4 gal/min.

Answers: 3

continue

Engineering, 04.07.2019 19:10, rhiannpelham60

The maximum shear stress and maximum flexural stress occur at the same location along a beam subjected to a non-uniform bending load. a)-trune b)- false

Answers: 2

continue

Do you know the correct answer?

It is desired to develop a strong Aluminum-based alloy with a shear strength on the order of G/100 b...