Engineering, 07.05.2021 01:00, trvptrav

1. Mohr-Coulomb shear failure criterion (20 points) In a tri-axial test (with load and confining pressure), the sample has the cohesion of 5 kPa, the angle of friction is 36 degree, It is loaded with a loading level of 50 kPa. Now we start to reduce the confining pressure. Question: what is the critical value of the confining pressure has to reach then the sample start to have shear failure

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 14:10, aliceohern

The y form of iron is known as: a) ferrite b) cementite c) perlite d) austenite

Answers: 3

continue

Engineering, 03.07.2019 15:10, margaret1758

If you were designing a bumper for a car, would you prefer it to exhibit elastic or plastic deformation? why? consider the functions of a bumper in both a minor "fender-bender" and a major collision.

Answers: 1

continue

Engineering, 04.07.2019 18:10, settasav9641

Abrake has a normal braking torque of 2.8 kip in and heat-dissipating cast-iron surfaces whose mass is 40 lbm. suppose a load is brought to rest in 8.0 s from an initial angular speed of 1600 rev/min using the normal braking torque; estimate the temperature rise of the heat dissipating surfaces.

Answers: 3

continue

Engineering, 04.07.2019 18:10, bckyanne3

Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.

Answers: 1

continue

Do you know the correct answer?

1. Mohr-Coulomb shear failure criterion (20 points) In a tri-axial test (with load and confining pre...