Engineering
Engineering, 05.05.2021 20:00, mpete1234567890

A venture tube is used to measure the flow rate of a liquid in a pipe (liquid density is 800 kg/m3). The pipe has a diameter of 10 cm and the smallest diameter of the venture has a diameter of 4 cm. A manometer with a manometer fluid of mercury (specific weight of 133 kN/m3) is used to calculate the flow rate which is connected to the venture section such that one leg is far upstream and the second leg is at the minimum diameter of the venture tube. If the flow rate is 0.05 m3/s determine the elevation change in the manometer fluid. a. 14.6 m
b. 9.28 m
c. 4.64 m
d. 2.32 m

answer
Answers: 3

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 18:10, xboxdude06
Slip occurs via two partial dislocations because of (a) the shorter path of the partial dislocation lines; (b) the lower energy state through partial dislocations; (c) the charge balance.
Answers: 1
image
Engineering, 04.07.2019 18:10, Strick1530
Which of the following components of a pid controlled accumulates the error over time and responds to system error after the error has been accumulated? a)- proportional b)- derivative c)- integral d)- on/off.
Answers: 2
image
Engineering, 04.07.2019 18:20, maustin5323
Athin walled concentric tube exchanger is used to cool engine oil from 160°c to 60°c with water that is available at 25°c acting as a coolant. the oil and water flow rates are each at 2 kg/s, and the diameter of the inner tube is 0.5 m and the corresponding value of the overall heat transfer coefficient is 250 w/m2. oc. how long must the heat exchanger be to accomplish the desired cooling? cpwater=4.187 kj/kg-candcpengine el=2.035 kj/kg·°c, oil . 120]
Answers: 1
image
Engineering, 04.07.2019 18:20, moneywaydaedae
Air is compressed isentropically from an initial state of 300 k and 101 kpa to a final temperature of 1000 k. determine the final pressure using the following approaches: (a) approximate analysis (using properties at the average temperature) (b) exact analysis
Answers: 1
Do you know the correct answer?
A venture tube is used to measure the flow rate of a liquid in a pipe (liquid density is 800 kg/m3)....

Questions in other subjects:

Konu
Mathematics, 05.04.2021 22:30