Engineering, 04.05.2021 04:00, Geo777
9. An elevator on a construction site is being operated at rated capacity of 6 tons, and is supported by two standard steel cables, each having a cross-section area of 1.25-in.2 and an effective modulus of elasticity of 12 * 106 psi. As the elevator is descending at a constant 500 ft/min, an accident causes the top of the cable, 200 ft above the elevator, to stop suddenly. (a) Calculate the Impact Factor. (b) Estimate the maximum elongation and maximum tensile stress developed in cable. (c) Estimate the maximum elongation and maximum tensile stress developed in cable if the cable length was 100 ft. (d) Comment on the effect of changing cable length on maximum tensile stress developed in the cable.
Answers: 3
Other questions on the subject: Engineering
Engineering, 04.07.2019 18:10, lillygrl100
For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater
Answers: 3
Engineering, 04.07.2019 18:10, michellerosas
Ajournal bearing has a journal diameter of 3.250 in with a unilateral tolerance of 20.003 in. the bushing bore has a diameter of 3.256 in and a unilateral tolerance of 0.004 in. the bushing is 2.8 in long and supports a 700-lbf load. the journal speed is 900 rev/min. find the minimum oil film thickness and the maximum film pressure for both sae 20 and sae 20w-30 lubricants, for the tightest assembly if the operating film temperature is 160°f. a computer code is appropriate for solving this problem.
Answers: 3
Engineering, 04.07.2019 18:10, genyjoannerubiera
Assuming compressible flow of air and that the measurements are done at flagstaff a pitot static tube that gives the difference of total and static pressure measures 0.35 m of mercury. what is the velocity of air? assume the temperature to be 300k. (submit your excel or matlab calculation sheet)
Answers: 1
Engineering, 04.07.2019 18:10, QueenLife4869
Awall of 0.5m thickness is to be constructed from a material which has average thermal conductivity of 1.4 w/mk. the wall is to be insulated with a material having an average thermal conductivity of 0.35 w/mk so that heat loss per square meter shall not exceed 1450 w. assume inner wall surface temperature of 1200°c and outer surface temperature of the insulation to be 15°c. calculate the thickness of insulation required.
Answers: 3
Do you know the correct answer?
9. An elevator on a construction site is being operated at rated capacity of 6 tons, and is supporte...
Questions in other subjects:
