Engineering
Engineering, 04.05.2021 01:20, dakshshberry

5. (5 points) Select ALL statements that are TRUE A. For flows over a flat plate, in the laminar region, the heat transfer coefficient is decreasing in the flow direction B. For flows over a flat plate, in the turbulence region, the heat transfer coefficient is decreasing in the flow direction C. For flows over a flat plate, the transition from laminar to turbulence flow only happens for rough surface D. For flows over a flat plate, if the length of the plate in the flow direction is long enough, the flows will inevitably become turbulent E. In general, turbulence flows have a larger heat transfer coefficient compared to laminar flows 6. (5 points) Select ALL statements that are TRUE A. For the flow in a pipe with constant cross-section area, both hydrodynamic and thermal boundary layer thicknesses increasingly grow in the flow direction B. In the hydrodynamic fully developed region, the mean velocity of the flow becomes constant C. In the thermally fully developed region, the mean temperature of the flow becomes constant D. For internal flows, if Pr>1, the flows become hydrodynamically fully developed before becoming thermally fully developed E. For internal flows, if Pr>1, the flows become thermally fully developed before becoming hydrodynamically fully developed

answer
Answers: 2

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 18:10, yasminothman02
An air conditioning system consist of a 5 cm diameter pipe, operating at a pressure of 200 kpa. the air initially enters the pipe at 15°c with a velocity of 20 m/s and relative humidity of 80%. if the heat supply throughout the process is 960 w, determine the relative humidity and the temperature at the outlet
Answers: 3
image
Engineering, 04.07.2019 18:10, 19deleonl
Coiled springs ought to be very strong and stiff. si3n4 is a strong, stiff material. would you select this material for a spring? explain.
Answers: 2
image
Engineering, 04.07.2019 18:10, michellerosas
Ajournal bearing has a journal diameter of 3.250 in with a unilateral tolerance of 20.003 in. the bushing bore has a diameter of 3.256 in and a unilateral tolerance of 0.004 in. the bushing is 2.8 in long and supports a 700-lbf load. the journal speed is 900 rev/min. find the minimum oil film thickness and the maximum film pressure for both sae 20 and sae 20w-30 lubricants, for the tightest assembly if the operating film temperature is 160°f. a computer code is appropriate for solving this problem.
Answers: 3
image
Engineering, 04.07.2019 18:10, wyattlb97
Water at the rate of 1 kg/s is forced through a tube with a 2.5 cm inner diameter. the inlet water temperature is 15°c, and the outlet water temperature is 50°c. the tube wall temperature is 14°c higher than the local water temperature all along the length of the tube. what is the length of the tube?
Answers: 3
Do you know the correct answer?
5. (5 points) Select ALL statements that are TRUE A. For flows over a flat plate, in the laminar reg...

Questions in other subjects:

Konu
Mathematics, 21.08.2019 04:10