Engineering
Engineering, 03.05.2021 17:40, preguntassimples

In a certain balanced three phase system each line current is a 5a and each line voltage is 220v . What is the approximate real power if the power factor is 0.7

answer
Answers: 3

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 18:20, rocio5649
Amixture of slurry and mud is to be pumped through a horizontal pipe of diameter 500 mm. the fluid behaves as a bingham plastic with a yield stress of 30 pa and viscosity 0.04 pa. s. describe the effects of the shear stress through a transverse section of the pipe by plotting the variation in shear stress and velocity profile: (i) just before the slurry starts to move (ii) as the slurry flows when the pressure gradient is double that in part (i)
Answers: 3
image
Engineering, 04.07.2019 19:20, GusGus11
The power source in a certain welding setup generates 3500w that is transferred to the low carbon steel work with a heat transfer factor of 0.85. the melting factor in the operation is 0.45. a continuous fillet weld is to be made with a cross-sectional area of 23 mm2 determine the travel speed at which the welding can be accomplished.
Answers: 3
image
Engineering, 06.07.2019 03:20, shelbellingswo
Aload of 10kn is to be suddenly applied to the free end of a vertical rod of length 500 mm, the upper end being rigidly fixed. 190 mechanical science what should the diameter of the rod be if the maximum stress in the rod is not to exceed 100 mpa? the tensile modulus of the rod is 205 gpa.
Answers: 2
image
Engineering, 06.07.2019 04:20, Okeh4001
An insulated tank truck containing 50,000 pounds of double-distilled, deionized water at 30 °c is pumped into a closed, refrigerated storage tank maintained at 5 °c in a facility located on top of mount mitchell, north carolina (elevation 6,684 feet & average july temperature of 84 °f). a)-determine the volume of the storage tank required to hold the purified water. b)- determine the initial and final pressure differences that must be overcome by a liquid pump assuming the storage tank initially contains air at 5 °c. assume the air is slowly bled out of the storage tank during the water transfer c.) during a routine operation today, the tank is slightly ruptured by a stainless steel pipe and a water acrosol of droplets begins to spray out of the storage tank. state all assumptions and determine the internal pressure within the water droplets produced
Answers: 1
Do you know the correct answer?
In a certain balanced three phase system each line current is a 5a and each line voltage is 220v . W...

Questions in other subjects:

Konu
Health, 30.10.2020 18:00