Engineering, 03.05.2021 14:00, cece4874

When prepping bare metal, which of these is used after a phosphoric acid based cleaner? Phosphoric acid based conditioner
Wash primer
Epoxy primer

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 15:10, margaret1758

If you were designing a bumper for a car, would you prefer it to exhibit elastic or plastic deformation? why? consider the functions of a bumper in both a minor "fender-bender" and a major collision.

Answers: 1

continue

Engineering, 04.07.2019 18:10, lillygrl100

For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater

Answers: 3

continue

Engineering, 04.07.2019 19:10, gabigalvis1091

What is the main objective of using reheat rankine cycle?

Answers: 3

continue

Engineering, 04.07.2019 19:10, batmanmarie2004

Afoot bridge is made as a simple deck, 4 m long, with a cross section 2 m (wide) and 20 cm thick, and made of wood. the deck is supported at the two ends. the maximum load allowable on the bridge is 10 tons, provided it is uniformly distributed on the deck. to sense this load, a strain gauge is placed at the center of the bridge and its resistance is monitored. if the sensor has a nominal resistance of 350 s2 and a gauge factor of 3.6, what is the reading of the strain gauge at maximum load? the modulus of elasticity for the wood used in the construction is 10 gpa.

Answers: 2

continue

Do you know the correct answer?

When prepping bare metal, which of these is used after a phosphoric acid based cleaner? Phosphoric...