11.D1 The following is a list of metals and alloys: Plain carbon steel Magnesium Brass Zinc Gray cast iron Tool steel Platinum Aluminum Stainless steel Tungsten Titanium alloy Select from this list the one metal or alloy that is best suited for each of the following applications, and cite at least one reason for your choice: (a) The block of an internal combustion engine (b) Condensing heat exchanger for steam (c) Jet engine turbofan blades (d) Drill bit (e) Cryogenic (i. e., very low temperature) container (f) As a pyrotechnic (i. e., in flares and fireworks) (g) High-temperature furnace elements to be used in oxidizing atmospheres

Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct

Which of the following ziegler nichols tuning methods the response of the controller to a step input should exhibit an s-shaped curve? a)-open loop mode b)-closed loop mode c)-both modes (open & closed) d)-none of the modes (open & closed)

A3-mm-thick panel of aluminum alloy (k 177 w/m-k, c 875 j/kg-k and ? = 2770 kg/m) is finished on both sides with an epoxy coating that must be cured at or above t,-150°c for at least 5 min. the production line for the curing operation involves two steps: (1) heating in a large oven with air at ts,0-175°c and a convection coefficient of h, 40 w/m2. k, and (2) cooling in a large chamber with air at 25°c and a con- vection coefficient of he 10 w/m2.k. the heating portion of the process is conducted over a time interval te which exceeds the ime required to reach 150°c by 5 min (h = r + 300 s). the coating has an emissivity of ? = 0.8, and the temperatures of the oven and chamber walls are 175 and 25°c, respectively. if the panel is placed in the oven at an initial temperature of 25°c and removed from the chamber at a safe-to-touch tempera ture of 37°c, what is the total elapsed time for the two-step curing operation?