A piston–cylinder device initially contains 0.8 m3 of nitrogen gas at 534 kPa and 22 °C. An electric heater within the device is turned on and is allowed to pass a current of 2 A for 8 min from a 107 -V source. Nitrogen expands at constant pressure, and a heat loss of 1,876 J occurs during the process. Determine the final temperature of nitrogen. Assume that Cp for nitrogen is equal to 1.039 KJ

Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.

Hydraulic fluid with a sg. of 0.78 is flowing through a 1.5 in. i. d. pipe at 58 gal/min. the fluid has an absolute viscosity of 11.8 x 105 lbf-sec/ft2. is the flow laminar, turbulent or within the critical range? give both a numerical reynolds number and a term answer.

Which one from below is not one of the reasons of planning failures? (clo3) a)-planner is careless. b-planner spend less time in the field but more time on the desk c)-planner is not qualified d)-planner does not have sufficient time to properly plan