Engineering, 19.04.2021 22:20, xxgissellexx

90 POINTS PLS ANSWER FAST ❗️❗️❗️❗️❗️❗️❗️❗️❗️❗️❗️

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, mm016281

What difference(s) did you notice using a pneumatic circuit over hydraulic circuit. explain why the pneumatic piston stumbles when it hits an obstacle.

Answers: 2

continue

Engineering, 04.07.2019 18:20, RiverH246

Air flows over a heated plate àt a velocity of 50m/s. the local skin factor coefficient at a point on a plate is 0.004. estimate the local heat transfer coefficient at this point. the following property data for air are given: density = 0.88kg/m3 , viscosity 2.286 x 10 ^-5 kgm/s , k = 0.035w/mk ,cp = 1.001kj/kgk. use colburn reynolds analogy.

Answers: 1

continue

Engineering, 06.07.2019 04:30, alyssa0888

Asharp-edged orifice is placed in a 10-in-diameter pipe carrying ammonia. if the volume flow rate is 25 gal/min, calculate the deflection of a water manometer (a) if the orifice diameter is 1.0 in and (b) if the orifice diameter is 7.0 in. the ammonia has a specific gravity of 0.83 and a dynamic viscosity of 2.5 x 10-6 lb s/t2

Answers: 3

continue

Engineering, 06.07.2019 05:20, carmenguabaoql9kv

A200-mm wide strip 25 mm thick is fed through a rolling mill w/two powered rolls each of radius = 250 mm. the work thickness is to be reduced to 22 mm in one pass at a roll speed of 60 rev/min. the average flow stress of the work material, as it passes through the rolls is 175 mpa. the friction coefficient between rolls and work material is 0.20. 1, determine a)-if friction is sufficient for rolling. b)- if friction is sufficient: c)- calculate roll force i calculate roll torque. d)- calculate roll power.

Answers: 2

continue

Do you know the correct answer?

90 POINTS PLS ANSWER FAST ❗️❗️❗️❗️❗️❗️❗️❗️❗️❗️❗️
...