Engineering, 12.04.2021 23:00, gumbyseth1969p45qjl
Saturated steam at 1.20bar (absolute)is condensed on the outside ofahorizontal steel pipe with an inside and outside diameter of 0.620 inches and 0.750 inches, respectively. Cooling water enters the tubes at 60.0°F and leaves at 75.0°F at a velocity of 6.00ft/s. (HINT: You may assume laminar condensate flow. You many also assume that the mean bulk temperature of the cooling water is equal to the wall temperature on the outside of the pipe, T".You may also neglect the viscosity correction in your calculations.)a)What are the inside
Answers: 3
Other questions on the subject: Engineering
Engineering, 04.07.2019 18:10, bckyanne3
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
Engineering, 04.07.2019 18:10, siri5645
At 12 noon, the count in a bacteria culture was 400; at 4: 00 pm the count was 1200 let p(t) denote the bacteria cou population growth law. find: (a) an expression for the bacteria count at any time t (b) the bacteria count at 10 am. (c) the time required for the bacteria count to reach 1800.
Answers: 1
Engineering, 04.07.2019 18:10, demarcuswiseman
Calculate the bore of a cylinder that has a stroke of 18 inches and an extension time of 6 seconds at a flow rate of 4 gal/min.
Answers: 3
Engineering, 04.07.2019 18:20, kodyclancy
Aquick transition of the operating speed of a shaft from its critical speed will whirl amplitude. (a) increase (b) limit (c) not affect (d) zero
Answers: 2
Do you know the correct answer?
Saturated steam at 1.20bar (absolute)is condensed on the outside ofahorizontal steel pipe with an in...
Questions in other subjects:
