Engineering, 12.04.2021 15:40, debbieparr4536

An element in plane stress is subjected to compressive stresses of magnitude . in the horizontal direction and tensile stresses of magnitude . in the vertical direction (see figure). Q-Also, shear stresses of magnitude . act in the directions shown. (a) Determine the stresses acting on an element oriented at a clockwise angle of 40° from the horizontal.

(b) Determine the maximum shear stresses and associated normal stresses. Using Mohr’s circle and show them on a sketch of a properly oriented element.

An element in plane stress is subjected to compressive stresses of magnitude . in the horizontal di

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 23:20, abbz13

Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct

Answers: 3

continue

Engineering, 04.07.2019 18:10, meganwintergirl

Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise

Answers: 3

continue

Engineering, 04.07.2019 18:10, aaliyah80

The drive force for diffusion is 7 fick's first law can be used to solve the non-steady state diffusion. a)-true b)-false

Answers: 1

continue

Engineering, 04.07.2019 18:10, redrosesxx

Water at 55c flows across a flat plate whose surface temperature is held constant at 95c. if the temperature gradient at the plate's surface for a given value of x is 18 c/mm, find a) local heat transfer coefficient. b) heat flux

Answers: 3

continue

Do you know the correct answer?

An element in plane stress is subjected to compressive stresses of magnitude . in the horizontal dir...