Engineering
Engineering, 09.04.2021 03:00, 06jesher44395

. A 200mV rms value sinusoidal signal is applied to and ideal 12 bits ADC. The full range peak-to-peak voltage of the ADC is 1.2V. a. Find the SNR of the ADC output. b. Now the input sinusoidal is full range but comes with an additive Gaussian noise with standard deviation of 0.5 V. What is the SNR of the input signal

answer
Answers: 3

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 18:10, ahmedeldyame
Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.
Answers: 1
image
Engineering, 04.07.2019 18:10, caitlynnpatton1208
Water in a partially filled large tank is to be supplied to the roof top, which is 8 m above the water level in the tank, through a 2.2-cm-internal-diameter pipe by maintaining a constant air pressure of 300 kpa (gage) in the tank. if the head loss in the piping is 2 m of water, determine the discharge rate of the supply of water to the roof top in liters per second.
Answers: 3
image
Engineering, 06.07.2019 03:10, kturvey225
Consider a 1.2 meter high and 2 meter wide glass window whose thickness is 6 mm and thermal conductivity is 0.78 w/m °c. the room temperature is maintained at 24 °c, while the outdoor temperature is -5 °c. the convective heat transfer coefficients on the inner and outer surfaces of the window are 10 w/m2 °c and 25 w/m2 °c respectively. (a) draw the thermal resistance network, etermine the steady rate of heat transfer t e glass window (c) determine the temperature of the inner surface of the window
Answers: 3
image
Engineering, 06.07.2019 04:30, tybreyonnaHco7855
Calculate the resolved shear stress on the (111)[011] slip system of a unit cell in an fcc nickel single crystal if a stress of 13.7 mpa is applied in the [001] direction of a unit cell.
Answers: 1
Do you know the correct answer?
. A 200mV rms value sinusoidal signal is applied to and ideal 12 bits ADC. The full range peak-to-pe...

Questions in other subjects:

Konu
History, 12.04.2021 06:20