Tungsten is being used at half its melting point (Tm≈3,400◦C) and astress level of 160 MPa. An engineer suggests increasing the grain size by afactor of 4 as an effective means of reducing the creep rate.(a)Do you agree with the engineer? Why? What if the stress level were equalto 1.6 MPa?(b)What is the predicted increase in length of the specimen after 10,000hours if the initial length is 10 cm?

Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise

Afluid flows with a velocity field given by v=(x/t)i.. determine the local and convective accelerations when x=3 and t=1.

Determine whether or not it is possible to compress air adiabatically from k to 140 kpa and 400 k. what is the entropy change during this process?