Engineering, 06.04.2021 03:40, TJxx187

Two dogbone specimens of identical geometry (same gauge lengths and cross-sectional areas) but made of two different materials: steel and aluminum are tested under tension at a fixed load rate. If the displacement rate needed to achieve the specified load rate for aluminum specimen is 0.001 inch/min, determine the displacement rate that must be applied on the steel specimen to achieve the specified load rate. Given, Young's modulus (E) of steel is 29,000 ksi and that of aluminum is 10,000 ksi.

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 16:10, TheOriginalMeyah

An electrical motor raises a 50kg load at a construct velencity .calculate the power of the motor, if it takes 40sec to raise the load through a height of 24m(take g =9.8n/g)

Answers: 2

continue

Engineering, 04.07.2019 18:10, jesuslovesusall3

Courses that are developed by subject matter experts, internal or extemal to the college or university. these programs are marketed by the school (clo2) marks a)-vocational schools b)-vendor training c)-colleges & universities d)-continuing education programs

Answers: 2

continue

Engineering, 04.07.2019 18:20, rjone8429

Asimple rankine cycle uses water as the working fluid. the water enters the turbine at 10 mpa and 480c while the condenser operates at 6 kpa. if the turbine has an isentropic efficiency of 80 percent while the pump has an isentropic efficiency of 70 percent determine the thermal efficiency

Answers: 1

continue

Engineering, 04.07.2019 18:20, samueltaye

Modern high speed trains do not have perpendicular expansion gaps where rails are joined end-to-end any more they are mostly welded together but what might happen if there was a spell of particularly hot weather that causes inspection of the tracks?

Answers: 1

continue

Do you know the correct answer?

Two dogbone specimens of identical geometry (same gauge lengths and cross-sectional areas) but made...