Engineering
Engineering, 03.04.2021 04:20, gustavitoperez

A rigid insulated tank is divided into 2 equal compartments by a thin rigid partition. One of the compartments contains air, assumed to be an ideal gas at 800 kPa and 300 K. The other compartment is under a vacuum. The partition is suddenly broken and the air rushes into the evacuated compartment. The tank pressure and temperature eventually equilibrate. a. Define the system you will use and draw a labeled schematic.
b. Write the energy balance for the system, making simplifications as appropriate.
c. What is the final temperature of the gas, K?
d. What is the final pressure, kPa?

answer
Answers: 2

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 18:20, hayleymckee
Steam enters a converging nozzle at 3.0 mpa and 500°c with a at 1.8 mpa. for a nozzle exit area of 32 cm2, determine the exit velocity, mass flow rate, and exit mach number if the nozzle: negligible velocity, and it exits (a) is isentropic (b) has an efficiency of 94 percent
Answers: 2
image
Engineering, 04.07.2019 18:20, Doogsterr
For each of the following process: a) sketch the p-v diagram, b)sketch t-s diagram, c) sketch t-v diagram, d) sketch the boundary work on one of the diagrams (a, b or c) and e) sketch the reversible heat transfer on one of the diagrams (a, b or c): 1- isobaric process from compressed liquid to superheated vapor 2- isothermal process from compressed liquid to superheated vapor 3- isentropic process from compressed liquid to superheated vapor
Answers: 3
image
Engineering, 04.07.2019 19:10, rayne40
A)-in the process of engineering design, explain the contribution of material selection. b)- explain the procedure of synthesis as is employed in engineering design. c)- is there any relationship between ergonomics and engineering design? explain. d)- safety consideration in engineering design includes human, product and the enviroment . explain how safety will be incorporated into the design?
Answers: 3
image
Engineering, 06.07.2019 03:20, carrietaylor234
Avertical steel rod of length 2.0 m and diameter 25 mm is rigidly fixed at its upper end and has a flange at its lower, free, end. what will be the maximum stress produced in the rod when a load of 20 kn is applied, (a) gradually to the lower end, (b) suddenly to the lower end, (c) by a collar falling from a height of 50 mm on to the flange?
Answers: 3
Do you know the correct answer?
A rigid insulated tank is divided into 2 equal compartments by a thin rigid partition. One of the co...

Questions in other subjects:

Konu
Mathematics, 26.05.2021 17:10