Engineering, 02.04.2021 01:30, conner87

g 50 points) A non-afterburning turbojet is being designed for operation at an altitude of 15 km and a Mach number of 1.8. The maximum stagnation temperature at the inlet of the turbine is 1500 K. The fuel is a jet fuel having a LHV of 43124 kJ/kg and fst is 0.06. The following efficiencies apply at this Mach number: ηd =0.9 ηb =0.98 ηt =0.92 ηc =0.9 rb =0.97 ηn =0.98 Use a gamma value of 1.4 up to the burner, and a value of 1.3 for the rest of the engine. Assume R is 0.287 kJ/kgK throughout the engine. Plot the specific thrust, TSFC, ηth, ηp, and ηo as a function of rc, the total pressure ratio across the compressor. Is there an optimum rc that minimizes TSFC? Is there an optimum rc that maximizes specific thrust? Consider a range of rc from 2 to 60. Assume the exhaust is ideally expanded. Also plot the nozzle area ratio as a function of rc.

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, niyawilliams23

Asingle-geared blanking press has a stroke of 200 mm and a rated capacity of 320 kn. a cam driven ram is assumed to be capable of delivering the full press load at constant force during the last 15 percent of a constant-velocity stroke. the camshaft has an average speed of 90 rev/min and is geared to the flywheel shaft at a 6: 1 ratio. the total work done is to include an allowance of 16 percent for friction a) estimate the maximum energy fluctuation b) find the rim weight for an effective diameter of 1.2 m and a coefficient of speed fluctuation of 0.10

Answers: 1

continue

Engineering, 04.07.2019 18:10, lillygrl100

For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater

Answers: 3

continue

Engineering, 04.07.2019 18:10, agpraga23ovv65c

Carbon dioxide gas expands isotherm a turbine from 1 mpa, 500 k at 200 kpa. assuming the ideal gas model and neglecting the kinetic and potential energies, determine the change in entropy, heat transfer and work for each kilogram of co2.

Answers: 2

continue

Engineering, 04.07.2019 18:10, Candi9697

A-mn has a cubic structure with a0 0.8931 nm and a density of 7.47 g/cm3. b-mn has a different cubic structure, with a0 0.6326 nm and a density of 7.26 g/cm3. the atomic weight of manganese is 54.938 g/mol and the atomic radius is 0.112 nm. determine the percent volume change that would occur if a-mn transforms to b-mn.

Answers: 2

continue

Do you know the correct answer?

g 50 points) A non-afterburning turbojet is being designed for operation at an altitude of 15 km and...