Engineering
Engineering, 31.03.2021 16:40, brownvester44

Task 1: The surviving group needs a vehicle that will take them over the rough terrain to search for other survivors and to collect data. Requirements:

Needs to travel over rough terrain.

Needs to use a universal joint.

Must be able to switch from two-wheel drive to four-wheel drive.

Task 2: The surviving group needs a machine that will rotate a solar collection dish from inside their labs. The machine must be located outside the building and around the corner.

Requirements:

Needs to have a minimum gear ratio of 1:5 or 5:1.

Must be located around a corner.

Needs to be angled toward the sun.

Must be able to follow the sun.

Task 3: Doctors need a machine to move all of their operating equipment and generators, at one time, from room to room. Some of these rooms are on the second floor, so the machine should be able to traverse both horizontally and vertically. One of the pieces of equipment is an old radio now used to regulate heartbeats, called a cardio regulator.

Requirements:

Must move all of the equipment at once.

Must create a cardio regulator.

The equipment is very heavy. The machine can move slowly, but it must be capable of carrying a lot of weight.

Task 4: For all members to survive, they must have food, water, and shelter. This means pumping water from the ground, cutting wood for building, and grinding grain for flour to eat.

Requirements:

Must create one machine that will perform all three tasks.

Must have only one input to run all devices in order to save energy.

Must be no larger than 10 in. x 10 in.

answer
Answers: 3

Other questions on the subject: Engineering

image
Engineering, 03.07.2019 15:10, EmilySerna
Heat is added to a piston-cylinder device filled with 2 kg of air to raise its temperature 400 c from an initial temperature of t1 27 cand pressure of pi 1 mpa. the process is isobaric process. find a)-the final pressure p2 b)-the heat transfer to the air.
Answers: 1
image
Engineering, 04.07.2019 18:10, ahmedeldyame
Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.
Answers: 1
image
Engineering, 04.07.2019 18:10, krystabrewer3
What are the two (02) benefits, which may result from a successful implementation of preventive maintenance (pm) program in an organization? (clo3)a)- lean manufacturing b)-overlapping responsibilities c)-the planner is not qualified d)-accurate contractor information e)-reduction in equipment redundancies f)-accurate stores information
Answers: 3
image
Engineering, 04.07.2019 18:20, alexis9263
Have a greater impact on maintenance productivity than any other support group. (clo5) a)-the top management b)-inventory and purchasing c)-sub-contracting d)-cmms
Answers: 2
Do you know the correct answer?
Task 1: The surviving group needs a vehicle that will take them over the rough terrain to search for...

Questions in other subjects:

Konu
Mathematics, 04.04.2020 20:04
Konu
History, 04.04.2020 20:04
Konu
Mathematics, 04.04.2020 20:04