Engineering
Engineering, 30.03.2021 23:30, kimlyn58p0wyn0

The defrost of an automobile function by discharging warm air on the inner surface of windshield. To prevent condensation of water on the inner surface, the temperature of the air and surface convection coefficient must be large enough to maintain a surface termperature Ts, i that is at least as high as the dew point temperature, Ts, i > Tdewp. Consider a windshield of length L=800 mm, and thickness t=6 mm, and driving conditions for which the vehicle moves at velocity of V=162 Km/h in ambient air at -15°C. The average convective heat trasfer coefficient on the outside of the windshield may be determined from the correlation. NuL=0.0295.Re^0.8LPr^1/3

Required:
a. If Tdewp=10 and T[infinity],i=50CC, what is the smallest value for hihi required to prevent condensation the inner surface.
b. Plot the thermal equivalent circuit. write the thermal resistances on the circuit

answer
Answers: 2

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 12:10, Ryantimes2
On a average work day more than work place firs are reorted
Answers: 1
image
Engineering, 04.07.2019 18:10, yasminothman02
An air conditioning system consist of a 5 cm diameter pipe, operating at a pressure of 200 kpa. the air initially enters the pipe at 15°c with a velocity of 20 m/s and relative humidity of 80%. if the heat supply throughout the process is 960 w, determine the relative humidity and the temperature at the outlet
Answers: 3
image
Engineering, 04.07.2019 18:10, Strick1530
Which of the following components of a pid controlled accumulates the error over time and responds to system error after the error has been accumulated? a)- proportional b)- derivative c)- integral d)- on/off.
Answers: 2
image
Engineering, 04.07.2019 18:20, rbgrh9465
An open feedwater heater operates at steady state with liquid entering at inlet 1 with t? = 40°c and pl = 1 .2 mpa. water vapor att2-200°c and p2 = 1.2 mpa enters at inlet 2. saturated liquid water exits with a pressure of pa 1.2 mpa. neglect heat transfer with the surroundings and all kinetic and potential energy effects, determine the mass flow rate of steam at inlet 2 if the mass flow rate of liquid water at inlet 1 is given as 2 kg/s.
Answers: 3
Do you know the correct answer?
The defrost of an automobile function by discharging warm air on the inner surface of windshield. To...

Questions in other subjects:

Konu
Biology, 18.11.2020 17:10