Engineering, 30.03.2021 20:40, tiahna1g
Problem 1 The force arm of a lever is 8 m long and the length of the load arm is 2 m. Calculate the force F needed to lift a 500 N load and find out the mechanical advantage of the lever.
Answers: 3
(1)
- Needed force, in newtons.
- Force arm, in meters.
- Load force, in newtons. 
- Load arm. in meters.
), no unit, is determined by following formula:
(2)
, 
and 
, then the load force needed to lift is:
Other questions on the subject: Engineering
Engineering, 04.07.2019 18:10, juansoto227711
Journeyman training is usually related (clo2) a)-to specific tasks b)-to cost analysis of maintenance task c)-to control process to ensure quality d)-to installation of machinery
Answers: 2
Engineering, 04.07.2019 19:10, shayshay7874
An electric kettle is made out of stainless steel, weighs two pounds (when empty) and is equipped with a heating element that consumes 2 kw of electricity. assuming that the water and the kettle are at the same uniform temperature at any moment of time, calculate the shortest possible time to bring 2 quarts of water from room temperature to the onset of boiling
Answers: 2
Engineering, 04.07.2019 19:20, mercedesamatap21hx0
To design a steam turbine to produce 12,000 hp power. a engineer comsiders using a steady state stean low st 1160fr and engineer considers using a steady state steam flow at 1160°r and 450 psia to drive this steam turbine. the exhaust of the steam is cooled by the lake (vacuum). heat losing to the surroundings is measured at a rate of 555.55 btu/s. (a) sketch the system with the given conditions. (b) neglecting kinetic and potential energy changes from inlet to exit, determine the volumetric flow rate of the steam at the inlet, (ft'/hr). must clearly show unit conversions at crtical terms.
Answers: 1
Engineering, 04.07.2019 19:20, brae72
Asimple speed reducer is composed of 2 spur gears. the pinion gear has a pitch diameter of 0.75" and 36 teeth while the driven gear has a pitch diameter of 4.0" and 192 teeth. a)-what is the diametral pitch of each gear? b)-if an electric motor rotating ccw at 3000 rpm is coupled to the pinion, what is the rotational speed of the driven gear? c)-if the torque delivered to the pinion is 1 n-m, what is the torque on the driven gear? d)-what is the power transmitted by the gear train?
Answers: 1
Do you know the correct answer?
Problem 1 The force arm of a lever is 8 m long and the length of the load arm is 2 m. Calculate the...
Questions in other subjects:
Mathematics, 05.11.2020 19:00
Mathematics, 05.11.2020 19:00
Mathematics, 05.11.2020 19:00
