Engineering, 30.03.2021 19:30, chasadyyy

Consider a home freezer compartment with dimensions of height 30 inches, width 60 inches, and depth 25 inches. Assume heat loss is from the five sides exposed to outside air (i. e. do not consider any heat loss through the bottom surface which the freezer sits on). For a Styrofoam insulation of thermal conductivity 0.025 W/m-K, what should be the minimum thickness of this insulation so that the total heat loss from the freezer compartment is less than 120 W? Assume the freezer air is at -20 C and the inside surface heat transfer coefficient is 5 W/m2-K, while the outside air temperature is 30 C and the outside surface heat transfer coefficient is 20 W/m2K.

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, bckyanne3

Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.

Answers: 1

continue

Engineering, 04.07.2019 18:20, RiverH246

Air flows over a heated plate àt a velocity of 50m/s. the local skin factor coefficient at a point on a plate is 0.004. estimate the local heat transfer coefficient at this point. the following property data for air are given: density = 0.88kg/m3 , viscosity 2.286 x 10 ^-5 kgm/s , k = 0.035w/mk ,cp = 1.001kj/kgk. use colburn reynolds analogy.

Answers: 1

continue

Engineering, 04.07.2019 19:20, holaadios222lol

Apiping systems consists of 6 m of 6-std type k and 12 m of 4-std type k, both drawn copper tubing. the system conveys ethylene glycol at a rate of 0.013 m3/s. the pressure drop across the system is to be calculated. there are two 90° elbows in the 6-in pipe, a reduction from the 6-in pipe to the 4-in pipe and four 90° elbows in the 4-in pipe. all fittings are soldered (same as flanged) and regular. the inlet and outlet of the system are at the same height.

Answers: 1

continue

Engineering, 04.07.2019 19:20, praveen35301

Amass-spring-viscous damper system of mass 3 kg has a frequency of 100 rad/s and is critically damped. its initial conditions are x(0)-3 mm and (0)-2.3 m/s. does the system overshoot its equilibrium position? prove your answer

Answers: 1

continue

Do you know the correct answer?

Consider a home freezer compartment with dimensions of height 30 inches, width 60 inches, and depth...