Engineering, 27.03.2021 14:10, biancabell3

Air flows adiabatically in a converging duct, which is fed from a large reservoir where the temperature and the pressure are 305 K and 210 kPa, respectively. At the end of the duct,
where the cross-sectional area is 0.0025 the pressure and temperature are 172 kPa and
278 K, respectively, Determine the Mach number at the end of the duct and find the mass
flow rate.

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 06.07.2019 03:10, iiisavageoreo

Two slings are used to lift a girder of length l and uniform weight per unit length. what is the best position for the slings if the bending moment due to the weight of the girder is to be kept to a minimum?

Answers: 2

continue

Engineering, 06.07.2019 03:30, relic7391

The load on a bolt consists of an axial pull of 10 kn together with a transverse shear force of 5 kn. the bolt material has a yield strength of syt syc 100 mpa. find the diameter of the bolt at factor of safety n-0.5, n 1 and n-2 using maximum shear stress theory

Answers: 3

continue

Engineering, 06.07.2019 04:10, johnbobjones

Aheat pump that operates on the ideal vapor compression cycle with refrigerant-134a is used to heat water from 15°c to 45°c at a rate of 0.12 kg/s. the condenser and evaporator pressures are 1.4 and 0.32 mpa, respectively determine: (a) the power input to the heat pump

Answers: 1

continue

Engineering, 06.07.2019 04:30, samvgesite

What is the principle of operation of a mechanical dynamometer?

Answers: 1

continue

Do you know the correct answer?

Air flows adiabatically in a converging duct, which is fed from a large reservoir where the tempera...