Engineering, 27.03.2021 14:00, chris3633

Q5/ A message signal with power equal to 0.5 watt is used to modulate a carrier signal with amplitude equal to 10 volt and frequency of 100 kHz. It is found that the power of the double side band represents the entire power of the bandpass signal. Answer the following: 1-According to the given information, what is the type of the modulation?
2-The total power of the bandpass signal : (Please write a number without units)
3-If the bandpass signal is applied on the input of a synchronous detector, then what is the value of the power of the output signal? (Please write a number without units)

Q5/ A message signal with power equal to 0.5 watt is used to modulate a carrier signal with amplitu

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, viicborella

Steel is coated with a thin layer of ceramic to protect against corrosion. what do you expect to happen to the coating when the temperature of the steel is increased significantly? explain.

Answers: 1

continue

Engineering, 04.07.2019 18:10, qwertylol12345

Different types of steels contain different elements that alter the characteristics of the steel. for each of the following elements, explain what the element does when alloyed with steel.

Answers: 2

continue

Engineering, 04.07.2019 18:10, Tyrant4life

Draw the engineering stress-strain curve for (a) bcc; (b) fcc metals and mark important points.

Answers: 1

continue

Engineering, 04.07.2019 18:20, hayleymckee

Steam enters a converging nozzle at 3.0 mpa and 500°c with a at 1.8 mpa. for a nozzle exit area of 32 cm2, determine the exit velocity, mass flow rate, and exit mach number if the nozzle: negligible velocity, and it exits (a) is isentropic (b) has an efficiency of 94 percent

Answers: 2

continue

Do you know the correct answer?

Q5/ A message signal with power equal to 0.5 watt is used to modulate a carrier signal with amplitud...