Engineering, 19.03.2021 16:00, avalianagames
The linear or mean intercept method is one way to estimate the average grain diameter, d. If you have several cross-sections of your sample so you can determine whether the grains are equi-axed (approximately the same length in all directions), rod or columnar shaped, or platy (like a dinner plate), you can increase the accuracy of your estimate by including a shape factor in your calculation.
(i) Use the mean intercept on the schematic microstructure for a hypothetical single phase metal below, to estimate the average grain size. Don't worry about including a shape factor.
Note: Mean intercept length, I = p where L:- measured length of the line(s) on the micrograph, P- number of times the line(s) intersect a grain boundary and M = the magnification of the micrograph; you may need to determine this from the scale bar.
(ii) If you use more than one line and you vary the orientation of your lines will you get a better estimate of the average grain size? Explain your answer in 1-3 bullets.
Answers: 3
Engineering, 04.07.2019 18:10, anna22684
Water at 70°f and streams enter the mixing chamber at the same mass flow rate, determine the temperature and the quality of the exiting stream. 0 psia is heated in a chamber by mixing it with saturated water vapor at 20 psia. if both streams enters the mixing chamber at the same mass flow rate, determine the temperature and the quality of the existing system.
Answers: 2
Engineering, 04.07.2019 18:10, katelynn73
Atmospheric air has a temperature (dry bulb) of 80° f and a wet bulb temperature of 60° f when the barometric pressure is 14.696 psia. determine the specific humidity, grains/lb dry air. a. 11.4 c. 55.8 d. 22.5 b. 44.1
Answers: 1
Engineering, 04.07.2019 18:10, jesuslovesusall3
Courses that are developed by subject matter experts, internal or extemal to the college or university. these programs are marketed by the school (clo2) marks a)-vocational schools b)-vendor training c)-colleges & universities d)-continuing education programs
Answers: 2
Engineering, 04.07.2019 18:20, CelesteN64
Most leaks in reciprocating air compressors can be detected and minimized by: (clo4) a)-detecting leakage areas using ultrasonic acoustic detector. b)-tightening joints and connections c)-replacing faulty equipment d)-all of the given options
Answers: 2
The linear or mean intercept method is one way to estimate the average grain diameter, d. If you hav...
French, 10.11.2021 21:40
Mathematics, 10.11.2021 21:40
History, 10.11.2021 21:40
Mathematics, 10.11.2021 21:40
Biology, 10.11.2021 21:40
Mathematics, 10.11.2021 21:40