Engineering, 19.03.2021 01:20, jcross11nate

With defaults declared, logic can be added to prompt for user inputs. This portion of the program should loop asking
the user for input each iteration until the user enters the
character 'c'.
Use conditional logic to check any user input if the length is
equal to 1, check for the character 'c' and make the loop exit,
the character 'a', and set the mode in the dictionary to the
loco_drone. MODE_ACCELEROMETER, and the characterſ
and set the mode in the dictionary to the
loco_drone. MODE_JOYSTICK. And if the length is greater
than 1, take the remaining character and cast it to an int,
setting it in the dictionary's calibration-enabled key.
W2. Implement the above-described code. Write your
code below.

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, qwertylol12345

Different types of steels contain different elements that alter the characteristics of the steel. for each of the following elements, explain what the element does when alloyed with steel.

Answers: 2

continue

Engineering, 04.07.2019 18:10, soreese02

An ideal otto cycle with air as the working fluid has a compression ratio of 8. the minimum and maximum temperatures in the cycle are 300 k and 1340 k. use constant specific heats at room temperature to determine (a) the amount of heat transferred to the air during the heat- addition kj/kg, (b) the thermal efficiency, and (c) the thermal efficiency of a carnot cycle ope limits. process, in rating between the same temperature

Answers: 2

continue

Engineering, 04.07.2019 18:10, katelynn73

Atmospheric air has a temperature (dry bulb) of 80° f and a wet bulb temperature of 60° f when the barometric pressure is 14.696 psia. determine the specific humidity, grains/lb dry air. a. 11.4 c. 55.8 d. 22.5 b. 44.1

Answers: 1

continue

Engineering, 04.07.2019 19:10, rayne40

A)-in the process of engineering design, explain the contribution of material selection. b)- explain the procedure of synthesis as is employed in engineering design. c)- is there any relationship between ergonomics and engineering design? explain. d)- safety consideration in engineering design includes human, product and the enviroment . explain how safety will be incorporated into the design?

Answers: 3

continue

Do you know the correct answer?

With defaults declared, logic can be added to prompt for user inputs. This portion of the program s...