Engineering, 12.03.2021 15:00, jarteria0

Consider a damped mass on a spring driven by a sinusoidal, externally applied force. (This is called a driven, damped harmonic oscillator and is common in aeroelastic structures like wings.) The resonant frequency in rad/s of this type of oscillator is: ω= √k/m- c^2/2mk

where the spring constant in N/m, the mass in kg, and the damping coefficient in kg/s are typically aspects of your system you can design. However, due to manufacturing variability, you do not have exact control over c. Instead c, k and m are independent and normally distributed with mean and standard devation as follows:

μ σ
c 2.6 0.34
m 9.84 1.42
k 17.3 1.85

Required:
Use MATLAB to simulate N=10000 random samples of the resonant frequency wr given samples from the above random variables, and compute the 5% and 95% percentile of the resonant frequency.

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, michellerosas

Ajournal bearing has a journal diameter of 3.250 in with a unilateral tolerance of 20.003 in. the bushing bore has a diameter of 3.256 in and a unilateral tolerance of 0.004 in. the bushing is 2.8 in long and supports a 700-lbf load. the journal speed is 900 rev/min. find the minimum oil film thickness and the maximum film pressure for both sae 20 and sae 20w-30 lubricants, for the tightest assembly if the operating film temperature is 160°f. a computer code is appropriate for solving this problem.

Answers: 3

continue

Engineering, 04.07.2019 18:10, xboxdude06

Slip occurs via two partial dislocations because of (a) the shorter path of the partial dislocation lines; (b) the lower energy state through partial dislocations; (c) the charge balance.

Answers: 1

continue

Engineering, 04.07.2019 18:20, esmemaluma00

Find the minimum film thickness for a journal bearing with the data below. shaft diameter, d-50 mm, clearance ratio, cdratio? 0.001, shaft speed, n 2000 rpm; bearing length. i 200 mm; eccentricity ration, ? -0.55. ( note, cdratio-ca/d) the minimum film thickness is um

Answers: 2

continue

Engineering, 04.07.2019 18:20, RiverH246

Air flows over a heated plate àt a velocity of 50m/s. the local skin factor coefficient at a point on a plate is 0.004. estimate the local heat transfer coefficient at this point. the following property data for air are given: density = 0.88kg/m3 , viscosity 2.286 x 10 ^-5 kgm/s , k = 0.035w/mk ,cp = 1.001kj/kgk. use colburn reynolds analogy.

Answers: 1

continue

Do you know the correct answer?

Consider a damped mass on a spring driven by a sinusoidal, externally applied force. (This is called...