Engineering, 12.03.2021 14:50, jcarver2494

An MSP430 is being used to monitor the temperature an experimental chamber. The temperature sensing "thermistor" being used inside the chamber is linear across the temperature range of interest (-80°C to 120°C) with the conversion formula Vtemp=0.0042*(Temp Cº) + 1.20 volts. Required:
a. What are the voltages corresponding to the minimum and maximum temperatures?
b. What are the output voltage of the sensor and the output code of the ADC12 if the temperature inside the chamber is 45ºC.

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 15:10, margaret1758

If you were designing a bumper for a car, would you prefer it to exhibit elastic or plastic deformation? why? consider the functions of a bumper in both a minor "fender-bender" and a major collision.

Answers: 1

continue

Engineering, 03.07.2019 23:20, abbz13

Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct

Answers: 3

continue

Engineering, 04.07.2019 18:10, bckyanne3

Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.

Answers: 1

continue

Engineering, 04.07.2019 18:10, xboxdude06

Slip occurs via two partial dislocations because of (a) the shorter path of the partial dislocation lines; (b) the lower energy state through partial dislocations; (c) the charge balance.

Answers: 1

continue

Do you know the correct answer?

An MSP430 is being used to monitor the temperature an experimental chamber. The temperature sensing...